Archery Store

As stated I have put my Hamskea Rest on a Prime Rival. Tunes and shoots well. But very noisy after the shot. Guessing it is in the spring somehow. Attached to lower limb. Suggestions to try. Or is it just a noisy rest?

I have a Cbe Tek Hybrid 5 pin and wondering how to change the fiber. I want to set the center pin up as my slider and was thinking of making it blue

Sent from my iPhone using Tapatalk

I know this has been beaten to death but I’m gonna beat it again. I recently sold both my sights and am in the market for a new one. I’m going away from a dovetailed sight and will be going to a direct mount on a hunting only setup. Of these three, which would you choose and why. I have done my research and know much about the Tommy Hogg having had a Hogg Father and Fast Eddie but don’t know much about the latter two. Any opinions and comments are welcome. Thanks much!

Is it possible to install the cord on the bottom axle rather than the limb. also doesnt pulling on one limb or one side of axle affect tuning on split limb ?? isnt that more or less what the yoke does..pull on one side ??

I will be using it for hunting and 3D which one is the better one of the two I mainly hunt out west and why did you pick the one that you picked

Went to my shop to pick up new halon 5 and I was excited to have them put on my new hamskea hybrid hunter…no such luck…first containment bar hut, took ot of and back of rest hit cables….I ended up swapping for a qad hdx which I have always run with no issue, just excited to try something different

I was replacing the Batteries I came across the Hybrid Mode wondering what it is, not seen this on any of the other Moultrie’s but never looked for it. Checked the Moultrie Website and it does not mention the Hybrid Mode any where. Just wondering what it is and how it works?

Anyone Know?

Thanks in Advance,
LFM

We’ll I cant find a bow I held and shot years
Ago. And there isn’t anything even close on
The market. I grew up shooting instinctive
With a compound. Gap shooting and was pretty
Good. I’m looking to build, or put together
Something as close to what I shot. Recurve
Take town riser, shelf rest, laminated recurve
Limbs, beaver silencers, pretty radical tear
Drop cams. The cames where very smooth.
It was a perfect blend of the traditional and
Compound worlds. Let off was I think 55%
Around 240 fps. Might of been faster.
My question is do you think this would be
A seller if brought to the market? With technologies
Of today it could be made pretty awesome. Light
Weight, still around 40" A.T.A but today’s cams
And Limbs I bet 300 fps could be done. Only
Trouble is that speed would be difficult to shoot
Accurately. Unless a release was used? Please
Good bad, what’s your thoughts?