Discount Prices on Archery Supplies Right Here
I picked up a perfexion last November used on here and loved everything about the bow. As time went on I began to notice it would make a very faint creaking noise at the initial stages of the draw cycle. It would not duplicate the noise unless I left it alone an hour or so and drew it again. It was always only on the first draw cycle.
As alwayslookin suggested I ordered new rear pocket screws from Gwen at xpedition archery (also very helpful). I disassembled the bow and applied door eze lubricant to the limb pads and coated the limb bolts as well as rear pocket screws with high pressure grease before reassembly. I also applied some lube under rear pocket screw head where they contact the pivot pad.
The last thing to note was that my camo finish had chipped where the pivot connected to the riser and alwayslookin said to chip that section of finish off the bow because in very rare instances that had been known to cause a slight noise. Anyways, after completing all these steps and reassembling its back to shooting just as good as ever but the noise is gone. Just wanted to share this information in case anyone else has the same issues.
Sent from my iPhone using Tapatalk
ArcheryTalk Forum: Archery Target, Bowhunting, Classifieds, Chat – General Archery Discussion